SLV-ED225PS, SLV-ED323ME, SLV-ED323SG, SLV-ED825PS, SLV-ED828ME, SLV-ED828SG, SLV-ED925PS, SLV-ED929MI, SLV-EZ121AZ, SLV-EZ424AZ, SLV-EZ725AZ, SLV-EZ727AZ - Sony VCR Service Manual (repair manual). Page 4

Read Sony SLV-ED225PS / SLV-ED323ME / SLV-ED323SG / SLV-ED825PS / SLV-ED828ME / SLV-ED828SG / SLV-ED925PS / SLV-ED929MI / SLV-EZ121AZ / SLV-EZ424AZ / SLV-EZ725AZ / SLV-EZ727AZ Service Manual online

— 4 —
IMPORTANT SERVICE GUIDE
 MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT
1) When installing the ass’y deck on the Main PCB, be sure to align the assembly point of mode switch.
ASSEMBLY POINT
(ALIGN TWO ARROWS)
Fig. 1
Fig. 2
1
 GEAR WORM
Fig. 3
FRAME
 HOW TO EJECT THE CASSETTE TAPE
    (If the unit does not operate on condition that tape is inserted into housing ass’y)
1) Turn the Gear Worm 1 clockwise in the direction of arrow with screw driver. (See Fig. 2)
    (Other method ; Remove the screw of Motor Load Ass’y, Separate the Motor Load Ass’y)
2) When Slider S, T are approached in the position of unloading, rotate holder Clutch counterclockwise after inserting screw driver in the
    hole of frame’s bottom in order to wind the unwiunded tape. (Refer to Fig. 3)
    (If you rotate Gear Worm 1 continuously when tape is in state of unwinding, you may cause a tape contamination by grease and
    tape damage. Be sure to wind the unwiunded tape in the state of set horizontally.)
3) Rotate Gear Worm 1 clockwise using screw driver again up to the state of eject mode and then pick out the tape. (Refer to Fig. 2)
Page of 65
Display

Click on the first or last page to see other SLV-ED225PS / SLV-ED323ME / SLV-ED323SG / SLV-ED825PS / SLV-ED828ME / SLV-ED828SG / SLV-ED925PS / SLV-ED929MI / SLV-EZ121AZ / SLV-EZ424AZ / SLV-EZ725AZ / SLV-EZ727AZ service manuals if exist.