SLV-D100 - Sony VCR Service Manual (repair manual). Page 5

— 5 —

12. Observe the original lead dress, especially near the

following areas : Antenna wiring, sharp
edges, and especially the AC and high voltage power
supplies. Always inspect for pinched, out-of-place, or
frayed wiring. Do not change the spacing between
components and the printed circuit board. Check the AC
power cord for damage. Make sure that leads and
components do not touch thermally hot parts.

13. Product Safety Notice :

Some electrical and mechanical parts have special safety-
related characteristics which might not be obvious from
visual inspection. These safety features and the protection
they give might be lost if the replacement component
differs from the original--even if the replacement is rated
for higher voltage, wattage, etc.

Components that are critical for safety are indicated in the
circuit diagram by shading, (       or       ).
Use replacement components that have the same ratings,
especially for flame resistance and dielectric strength
specifications. A replacement part that does not have the
same safety characteristics as the original might create
shock, fire or other hazards.