Read Sony XBR-55HX925 Service Manual online
XBR-55HX925 A-2
APPENDIX A - REMOVING THE REAR COVER
REMOVING THE POWER CORD FROM THE
REAR COVER
The AC Power Cord is connected to the Power Supply Board and
then routed out through the Rear Cover. When removing the Rear
Cover use caution to avoid pulling the AC Power Cord which may
damage the cord.
Caution: These instructions should be followed whenever
removing the Rear Cover.
1. Using the instructions provided in the
“Rear Cover
and Switch Unit Removal” on page 41
, remove the
screws from the Rear Cover.
2. Remove 1 screw from AC Cover.
3. Gently start to lift the Rear Cover to detach it from the
Bezel.
4. Continue pulling the Rear Cover up from the Bezel one
section at a time.
5. Lift up Rear Cover with AC Cover and AC Power Cord
attached.
NOTE: Hold AC Power Cord while lifting up Rear
Cover. Do not pull the AC Power Cord or damage the
connector on the Power Board.
6. Disconnect the AC Power Cord to detach from Power
Supply Board.
Click on the first or last page to see other XBR-55HX925 service manuals if exist.