Read Sony KV-PG21M10 Service Manual online
–
11
–
KV
-PG21M10
-PG21M10
RM-952
2-7. PICTURE TUBE REMOVAL
Note:
•
Please make sure the TV set is not in standing position before removing necessary
CRT support located on bottom right and left.
CRT support located on bottom right and left.
!™
!£
8
Demagnetic coil
4 Four screws
(washer head)
(BVTP 3
(BVTP 3
× 12)
!º
Two screws
(Tapping 5+
Crown Washer)
(Tapping 5+
Crown Washer)
3 Speaker
(5
× 9cm)
6 Tension
spring
7
Chassis assy
5 Deflection
yoke
2
CV board
1
Anode cap
Coating earth assy
!∞
Picture tube
!¢ Cushion
9Two screws
(Tapping 5 +
Crown Washer)
Crown Washer)
!¡
Holder DGC
Cushion (50x550) DGC
Cushion (35x250) DGC
A Board
CRT Support Block
Slim Beznet
CRT Support Block
Screw Location
•REMOVAL OF ANODE-CAP
NOTE : • The picture tube is upside down, and the position for the anode cap
and tension springs are changed accordingly.
• Please remove necessary CRT support located on top left, top right,
bottom left, bottom right, prior to removing the CRT.
•REMOVING PROCEDURES
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
3 When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow
arrow
c.
• HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects.
2 Do not press the rubber too hard so as not to damage the inside of anode-cap.
2 Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3 Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
a
a
b
b
c
Anode Button
Click on the first or last page to see other KV-PG21M10 service manuals if exist.