KV-PG14M40 (serv.man2) - Sony TV Service Manual (repair manual). Page 11

–

 11 

–

•REMOVAL OF ANODE-CAP

NOTE : After removing the anode, short circuit the anode of the picture tube and

the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.

•REMOVING PROCEDURES

1 Do not damage the surface of anode-caps with sharp shaped objects.
2 Do not press the rubber too hard so as not to damage the inside of anode-cap.

3 Do not turn the foot of rubber over too hard.

• HOW TO HANDLE AN ANODE-CAP

3 When one side of the rubber cap is separated from the anode button,  the anode-cap

c

.

2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b

.

1 Turn up one side of the rubber cap in the direction indicated by the arrow a

.

a

a

b

b

Anode button

c

•

Please make sure the TV set is not in standing position before removing necessary
CRT support located on bottom right and left.

1) Place the TV set with the CRT face down on a cushion jig.
2) Remove the rear cover.
3) Unplug all inter connecting leads from the Deflection Yoke, Degaussing Coils and

CRT grounding strap.

8

Coil Degaussing

qa

Four screws 
(washer head)
(BVTP 3 

× 

12)

qd

!º

Two screws
screw (5) 
Tapping

qs

Speaker
(5 

× 

9cm)

9

Tension
spring

7

Chassis assy

6

Deflection
yoke

5

C board

Coating earth assy

!∞

Picture tube

!¢

 Cushion

qd

Two screws
screw (5) 
Tapping

A Board

Beznet

CRT Support Block

4

Anode 
cap

Screw Location