KV-HG21M50 (serv.man3) - Sony TV Service Manual (repair manual). Page 8

– 7 –

CAUTION :
1.  Do not overpull the wires during dressing

--> avoid disconnection of wires.

2.  Make sure wires are kept away from

sharp edges, heatsinks & other
high-temperature parts.

 

 

 

 

R82

R82

R88

 

Connector Assy,

3P

Refer to
printing:
GRAY wire to
Pin 3 (KEY)

W06

W06

UL wire

P/N 1-923-082-

Refer to
printing:
WHITE wire
to
Pi 1 (GND)

CAUTION:
Make sure Connector Assy,
3P (P/N: 1-910-031-76) is
inserted to correct pins:
--> WHITE wire to Pin 1
--> GRAY wire to Pin 3
--> Pin 2 is NOT connected

CAUTION:
Prevent tie, cable from
touching rear cover or any
enclosures by turning them
away from it
--> avoid rattle sound. Also
prevent tie, cable's end from
touching solder side of board

CAUTION:
Prevent tie, cable from touching
rear cover or any enclosures by
turning them away from it
--> avoid rattle sound. Also
prevent tie, cable's end from
touching solder side of board.

CAUTION:
Dress & control mounted wires on C boards
if necessary :
--> ensure wires do not get trapped during
solder dip process
--> ensure wires do not get punched by ICT
jig. (modify ICT jig if applicable)

Dress UL Wire (1-923-082-52) according to Figure 1(b) as 
shown
Note : Ensure UL wire does not touch high temperature 
resistors R828, R829 & R889

Ensure UL wire does not touch high
temperature resistors R828, R829 & R889