Read Sony KV-FA21M63 Service Manual online
– 10 –
KV-FA21M63/M83/
N
63
RM-GA002
2-3. FOCUS ADJUSTMENT
FOCUS adjustment should be completed before W/B
adjustment.
adjustment.
1. Receive digital monoscope pattern.
2. Set Picture Mode to "VIVID".
3. Adjust focus VR to obtain a just focus at the center of
2. Set Picture Mode to "VIVID".
3. Adjust focus VR to obtain a just focus at the center of
the screen.
4. Change the receiving signal to white pattern and blue
back.
5. Confirm magenta ring is not noticeable. In case magenta
ring is obvious, then adjust FOCUS VR to balance
magenta ring and FOCUS.
magenta ring and FOCUS.
2-4. G2 (SCREEN) ADJUSTMENT
1. Set the following condition:
– Picture and Brightness to "STANDARD".
– TV to Video mode.
– WHBL 016 "RGBB" to 01
– TV to Video mode.
– WHBL 016 "RGBB" to 01
2. Connect R, G, B of the C/CV board cathode to
oscilloscope.
3. Adjust Brightness to obtain the cathode value to the
value stated below.
4. Adjust SCREEN VR on the FBT until the scanning line
disappears.
5. Finally set WHBL 016 "RGBB" back to 00.
165
± 2VDC
2-5. WHITE BALANCE ADJUSTMENT
1. Set to Service Mode.
2. Input white raster signal using signal generator.
3. Set the following condition:
2. Input white raster signal using signal generator.
3. Set the following condition:
Picture "VIVID", PICT 006 "WTS" to 00.
4. At Highlight condition, select WHBL 03 "GDRV" and 04
"BDRV" with 1 and 4 button of the remote
commander then adjust the data with 3 and 6 button.
commander then adjust the data with 3 and 6 button.
5. At Cutoff, select WHBL 000 "BKOR" and 001 "BKOG"
and adjust the data.
6. Perform adjustment at Highlight and Cutoff condition
until it reaches its target.
7. Write data into memory by pressing [MUTING]
t -.
8. Finally set PICT 006 "WTS" back to its original data.
2-6. SUB BRIGHT ADJUSTMENT
1. Set TV to RF mode.
2. Input PAL monoscope to RF mode.
3. Set Brightness 50% and Picture to "MINIMUM".
4. Select WHBL 010 "SBRT" with 1 and 4 button of the
2. Input PAL monoscope to RF mode.
3. Set Brightness 50% and Picture to "MINIMUM".
4. Select WHBL 010 "SBRT" with 1 and 4 button of the
remote commander and adjust its data with 3 and 6
with cut-off level and slightly glimmer.
a. Cut-off
with cut-off level and slightly glimmer.
a. Cut-off
: 10Ike + 2 step
: 10Ire + 2 step (NTSC)
: 10Ire + 2 step (NTSC)
Slightly glimmer : 20IRE + 2 steps
: 20IRES + 2 step (NTSC)
5. Copy data from RF to Video.
6. Write into the memory by pressing [MUTING]
6. Write into the memory by pressing [MUTING]
t -.
FOR NTSC MODEL
7. Input monoscope signal.
8. Follow step 3 to 6.
8. Follow step 3 to 6.
Click on the first or last page to see other KV-FA21M63 service manuals if exist.