KV-DR29M81 - Sony TV Service Manual (repair manual). Page 9

– 9 –

• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT

shield or carbon paint on the CRT.

• REMOVING PROCEDURES

1 Turn up one side of the rubber cap in the direction

indicated by the arrow a.

2 Using a thumb pull up the rubber cap firmly in the direc-

tion indicated by the arrow b.

3 When one side of the rubber cap is separated from the

anode button,  the anode-cap can be removed by
turning up the rubber cap and pulling it up in the
direction of the arrow c.

• HOW TO HANDLE AN ANODE-CAP

1 Do not damage the surface of anode-caps with

2 Do not press the rubber too hard so as not to

3 Do not turn the foot of rubber over too hard.

a

a

b

b

c

 Anode Button

# Band, DGC(2) Removal

4 Anode Cap Removal

Remove Clip, DGC(3)

( Earth Coating Assy(2) Removal

6 Loosen the Neck Assembly 

fixing screw and remove

8 Loosen the Deflection Yoke

fixing screw and remove

5 C Board Removal

9 Chassis Assy Removal

7 VM Board Removal

& Spring Tension(2) 

Removal

" Supports, CRT(2) Removal

% DGC(2) Removal

$ Holder, DGC(2) Removal

) Nut, Locking (4)  

~

 Nut special CRT (4)  

! Bracket Woofer(2) Removal (KV-DR34M90B)

• Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom

right and left.

• When removing the Nut Locking: first make sure to hold the Nut special CRT with a spanner while opening the Nut

Locking using a torque driver. Then proceed to remove the Nut special CRT using a torque driver.

1) Place the TV set with the CRT face down on a cushion (jig).
2) Removal the Rear Cover.
3) Unplug all interconnecting leads from the Deflection Yoke, Neck Assy, Degaussing Coils and CRT grounding strap.