KV-DR29M50 - Sony TV Service Manual (repair manual). Page 14

– 14 –

(2) Dynamic Convergence Adjustment
Preparation:
•

Before starting this adjustment, adjust the horizontal static
convergence and the vertical static convergence.

•

Set the PICTURE and BRIGHTNESS to normal.

1

Receive the dot/hatch pattern signal and adjust picture quality
by the menu.

2

Correct horizontal mis-convergence of red and blue of both
sides on the X axis.
When red is outside insert TLH convergence piece to right
side (TLH +) views from DY neck. And when blue is outside,
insert it to left side (TLH –) and take both sides.

To able to become balance of XCV on the X axis well.

Correct the vertical mis-convergence of red and blue of
vertically sides on the Y axis.

Adjust horizontal mis-convergence of red and blue of
vertically sides on the Y axis. Mentioned above steps 2 to 4
are adjusting respectively perform minuteness tracking.

4

BMC (Hexapole) Magnet.
If the red, green and blue dots are not balanced or aligned,
then use the BMC magnet to adjust in the manner described
below.

5

Y separation axis correction magnet adjustment.

1. Receive the cross-hatch signal and adjust [PICTURE] to

[MIN] and [BRIGHTNESS] to [STANDARD].

2. Adjust the Y separation axis correction magnet on the neck

assembly so that the horizontal lines at the top and bottom of
the screen are straight.

Note
1. The Red and Blue magnets should be equally far from the

horizontal center line.

2. Do not separate the Red and Blue magnets too far.

(Less than 8 mm)

R G

B

R

G

B

R

G B

R

B

R

G

G

G

B

R

B

Blue

Red

VM board

Blue

Red

VM board

Neck assy

Neck assy

R

(B)

B

(R)

B

(R)

R

(B)

XCV

BMC magnet

C board

RV9001

VM board

TLV1

YCH

TLV2

b

a

c

d

a-d : screen-corner
        misconvergence