KV-DB29M61 - Sony TV Service Manual (repair manual). Page 7

Read Sony KV-DB29M61 Service Manual online

– 7 –
KV-DB29M61/M91/M98
RM-GA001
• REMOVAL OF ANODE-CAP
Note:
• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or
carbon paint on the CRT.
• REMOVING PROCEDURES
Turn up one side of the rubber cap in the direction
indicated by the arrow a.
Using a thumb pull up the rubber cap firmly in the direction
indicated by the arrow b.
When one side of the rubber cap is separated from the
anode button,  the anode-cap can be removed by turning
up the rubber cap and pulling it up in the direction of the
arrow 
c.
• HOW TO HANDLE AN ANODE-CAP
Do not damage the surface of anode-caps with sharp
shaped objects.
Do not press the rubber too hard so as not to damage
the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built
into the rubber.
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the
rubber.
1-12. PICTURE TUBE  REMOVAL
Note:
• Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right
and left.
1) Remove the Rear Cover.
2) Unplug all interconnecting leads from the Deflection Yoke, Neck Assy, Degaussing Coils and CRT grounding strap. Remove
Chassis Assy.
3) Place the TV set with the CRT face down on a cushion (jig).
a
a
b
b
c
 Anode Button
qa
 Earth Coating Assy
4 Anode Cap Removal
8 Band, DGC Removal
9
 Holder, DGC Removal (x2)
qd
 Supports, CRT Removal (x2)
qs
 Spring Tension Removal (x2)
qf
 Screw Tapping 7+ Crown Washer
q;
 Degaussing Coil
6 Loosen the Neck Assembly
 
fixing screw and remove
 
Neck Assy & VM1 Board
7
 Loosen the Deflection Yoke
  fixing screw and remove
5 C1 Board Removal
Page of 127
Display

Click on the first or last page to see other KV-DB29M61 service manuals if exist.