Read Sony KV-DA32M36 Service Manual online
– 65 –
KV-DA32M36
RM-W105
7-2. SCHEMATIC DIAGRAM INFORMATION
Note:
•
•
All capacitors are in
µF unless otherwise noted.
•
All electrolytic capacitors are rated at 50V unless otherwise noted.
•
All resistors are in ohms.
k
k
Ω = 1000Ω, MΩ = 1000kΩ
•
Indication of resistance which does not have rating electrical
power is as follows.
power is as follows.
Pitch: 5 mm
Rating electrical power 1/4W (CHIP: 1/10W)
Rating electrical power 1/4W (CHIP: 1/10W)
•
: nonflammable resistor.
•
: fusible resistor.
•
¢
: internal component.
•
: panel designation or adjustment for repair.
•
All variable and adjustable resistors have characteristic curve B
unless otherwise noted.
unless otherwise noted.
•
Readings are taken with a color-bar signal input.
no mark
no mark
: Common
(
)
: PAL
[
]
: NTSC 3.58
•
Readings are taken with a 10M
Ω digital multimeter.
•
Voltage are dc with respect to ground unless otherwise noted.
•
Voltage variations may be noted due to normal production
tolerances.
tolerances.
•
All voltage are in Volt.
•
✽
: Cannot be measured.
•
Circled numbers are waveform references.
•
: B +bus.
•
: B –bus.
•
k
: signal path.
Note: The reference number which starts with Wxxx
(eg: W003) indicates a wire to wire connection.
Note: Components marked as XX are not fitted on
this model.
Reference information
RESISTOR
RESISTOR
: RN
METAL FILM
: RC
SOLID
: FPRD
NONFLAMMABLE CARBON
: FUSE
NONFLAMMABLE FUSIBLE
: RS
NONFLAMMABLE METAL OXIDE
: RB
NONFLAMMABLE CEMENT
: RW
NONFLAMMABLE WIREWOUND
:
✽
ADJUSTMENT RESISTOR
COIL
: LF-8L
MICRO INDUCTOR
CAPACITOR
: TA
TANTALUM
: PS
STYROL
: PP
POLYPROPYLENE
: PT
MYLAR
: MPS
METALIZED POLYESTER
: MPP
METALIZED POLYPROPYLENE
: ALB
BIPOLAR
: ALT
HIGH TEMPERATURE
: ALR
HIGH RIPPLE
Note:
The component identified by shading and mark
! are critical for safety. Replace only with part
number specified.
! are critical for safety. Replace only with part
number specified.
Note: "A" board schematic diagram is divided into 4 blocks.
"BH1" board schematic diagram is divided into 2 blocks.
"D" board schematic diagram is divided into 2 blocks.
"VM" board schematic diagram is divided into 2 blocks.
Each block is named by its function and block "number".
"D" board schematic diagram is divided into 2 blocks.
"VM" board schematic diagram is divided into 2 blocks.
Each block is named by its function and block "number".
eg: Hercules/Tuner/Audio/Regulator (Block 001) Joint
connection between boards can be identified using the
block number followed by the grid's guide.
block number followed by the grid's guide.
eg: –< NVM_SCL
003:1I
Meaning: Block 001 joint "NVM_SCL" is connected to
Block 003 joint "NVM_SCL" located at grid 1I.
Block 003 joint "NVM_SCL" located at grid 1I.
Click on the first or last page to see other KV-DA32M36 service manuals if exist.