KV-DA29M81 - Sony TV Service Manual (repair manual). Page 8

– 8 –

• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT

shield or carbon paint on the CRT.

• REMOVING PROCEDURES

1 Turn up one side of the rubber cap in the direction

a.

2 Using a thumb pull up the rubber cap firmly in the direc-

b.

3 When one side of the rubber cap is separated from the

c.

• HOW TO HANDLE AN ANODE-CAP

1 Do not damage the surface of anode-caps with

2 Do not press the rubber too hard so as not to

3 Do not turn the foot of rubber over too hard.

• Please make sure the TV set is not in standing position before removing necessary CRT support located on

bottom right and left.

• When removing the Nut Locking: first make sure to hold the Nut special CRT with a spanner while opening the Nut

Locking using a torque driver. Then proceed to remove the Nut special CRT using a torque driver.

1) Place the TV set with the CRT face down on a cushion (jig).
2) Removal the Rear Cover.
3) Unplug all interconnecting leads from the Deflection Yoke, Neck Assy, Degaussing Coils and CRT grounding strap.

!∞ Earth Coating Assy

5 Degaussing Coil

4 Anode Cap Removal

7 C Board Removal

8 VM Board Removal

9 Chassis Assy Removal

!£ Spring Tension(2)
     Removal

!™

 Support, CRT Removal (x2)

!¢ Holder, DGC
     Removal (x2)

!§ Screw, Tapping 7 +
     Crown Washer (4)

!º Loosen the Deflection Yoke

fixing screw and remove

!¶ Band, DGC Removal

6 Loosen the Neck Assembly
     fixing screw and removal

a

a

b

b

c

 Anode Button