KV-BZ21M10 - Sony TV Service Manual (repair manual). Page 6

– 6 –

qf

 Screw, Tapping 5+

     Crown Washer (x4)

4

 Anode Cap Removal

7

 Degaussing Coil

6

 Loosen the Neck Assembly 

fixing screw and remove
Neck Assy 

qa

 Loosen the Deflection Yoke

fixing screw and remove

5

 C Board Removal

9

 Spring Tension(2) 

Removal

0

 Holder, DGC

Removal (x2)

qd

 Earth Coating Assy

qs

 Supports, CRT

Removal (x2)

8

 Chassis Assy Removal

• The picture tube is upside down for KV-BZ21M10 (Oceania) and the position for the anode cap and tension springs are

changed accordingly.

• Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right

and left.

1) Place the TV set with the CRT face down on a cushion.
2) Remove the Rear Cover.
3) Unplug all interconnecting leads from the Deflection Yoke, Neck Assy, Degaussing Coils and CRT grounding strap. Remove

Chassis Assy.

• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield

or carbon paint on the CRT.

• REMOVING PROCEDURES

1 Turn up one side of the rubber cap in the direction

indicated by the arrow A.

2 Using a thumb pull up the rubber cap firmly in the direction

indicated by the arrow B.

3 When one side of the rubber cap is separated from the

anode button,  the anode-cap can be removed by turning
up the rubber cap and pulling it up in the direction of the
arrow C.

• HOW TO HANDLE AN ANODE-CAP

1 Do not damage the surface of anode-caps with sharp

2 Do not press the rubber too hard so as not to damage

3 Do not turn the foot of rubber over too hard.

A

A

B

B

C

 Anode Button