KV-BZ213M50 - Sony TV Service Manual (repair manual). Page 11

– 10 –

 

 

 

 

 

For illustration 

 

 

 

 

Black tape

Ensure DGC

Connector is kept

behind of DGC

DGC Connector in front of DGC before

dress with standing purse lock.

Make sure wire does not touch heatsink

or other high temperature parts

Standing purse lock

AC Power Cord

Lead Assy, Earth

DGC Conn

Lead Assy, Speaker

For 2 Spk models

For 1 Speaker models

Purse lock

Spring extension

Left

Lead Assy, Speaker

DGC Conn

Right Speaker

Keep Lead Assy,

Speaker (RED+BLK)

Ensure wires are

kept away from heatsink

Lead Assy, Speaker (RED+BLK) is

sandwiched between DGC & CRT surface

Insert Lead Assy, Speaker (WHT+BLK)

followed by AC Power Cord into CRT

support's hook. Make sure Lead Assy,

Speaker (WHT+BLK) is secured behind 

AC Power cord

Keep wires away from sharp

edge of spring extension --> to

prevent scratching on wires.

Lead Assy

Left Speaker

Insert AC Power Cord into CRT support's hook

For 2 Speaker models

Ensure DGC
Connector is
kept behind of
black tape.

Earth Assy, Coating is in

front of DGC before looping

it once around DGC.

Earth Assy, Coating is in

front of DGC before looping it

once around DGC.

Connected

to C board.

From braided wire of

Earth Assy, Coating

Earth Assy, Coating

Dress Connector Assy,

7P with cable tie at

alignment hole A. Make

sure end of cable tie is

facing inwards

-->

 

to prevent rattle sound  

Ensure Earth Assy, Coatin is close

to CRT surface before making a

loop around DGC

DGC

CAUTION :
1. Prevent cable tie from touching
rear cover or any enclosures by
turning them away from it
--> to avoid ratlle sound & prevent
cable tie from touching solder side
of board.