Read Sony KV-BZ213M10 Service Manual online
– 7 –
KV-BZ213M10, M40, M50, P50, BZ216M80/H, M81
RM-GA002
SECTION 2
WIRE DRESSING
CAUTION :
1. Do not overpull the wires during dressing
1. Do not overpull the wires during dressing
--> avoid disconnection of wires.
2. Make sure wires are kept away from
sharp edges, heatsinks & other
high-temperature parts.
high-temperature parts.
2-1. Mount Caution on A/C
2-2. Connector Assy, 5P dressing (for models with Component, Rear)
A
C
R828
R829
Mounted Wire (DIP)
Plug (A/I)
R889
Lead Assy, G2 & 200V wire on C
UL wire P/N 1-923-082-52 on A
W068
W069
CN703
W700
CN801
UL wire
P/N 1-923-082-52
Ensure UL wire does not touch high
temperature resistors R828, R829 & R889
temperature resistors R828, R829 & R889
W700:
Board-in Lead
Assy, G2
Board-in Lead
Assy, G2
CAUTION:
Dress & control mounted wires (Lead Assy, G2 & 200V wire) on
C board if necessary :
--> ensure wires do not get trapped during solder dip process
--> ensure wires do not get punched by ICT jig (modify ICT jig if
applicable)
Dress & control mounted wires (Lead Assy, G2 & 200V wire) on
C board if necessary :
--> ensure wires do not get trapped during solder dip process
--> ensure wires do not get punched by ICT jig (modify ICT jig if
applicable)
CAUTION:
1) Keep UL wire close to board surface
2) Make sure wires are kept away from resistor
R828 & other high-temperature parts
1) Keep UL wire close to board surface
2) Make sure wires are kept away from resistor
R828 & other high-temperature parts
CN703:
Ensure Pin 1
is connected
to orange
wire (200V)
Ensure Pin 1
is connected
to orange
wire (200V)
R121
Make sure Conn Assy, 5P
does not touch resistor, R121
Lead Assy,
Jumper
Conn Assy, 5P
Connector Assy, 5P & Lead Assy, Jumper
go around shield case & dress with pin wire A021
Make sure the UL tape is
positioned
at the sharp edge of shield case
to prevent wire from being scratched
Keep Lead Assy, Jumper away
from shield case --> C/M for
OSD drift from RF to Video Mode
Make sure the Connector Assy, 5P
(YUV) is kept close to board surface.
CAUTION :
1) Dress Lead Assy, Jumper according to the green route.
=> Ensure Lead Assy, Jumper is dress away from shield case in the boxed area.
=> Ensure Lead Assy, Jumper is dress below Conn Assy, SP(YUV).
1) Dress Lead Assy, Jumper according to the green route.
=> Ensure Lead Assy, Jumper is dress away from shield case in the boxed area.
=> Ensure Lead Assy, Jumper is dress below Conn Assy, SP(YUV).
Click on the first or last page to see other KV-BZ213M10 service manuals if exist.