KV-AR29K90 - Sony TV Service Manual (repair manual). Page 9

– 9 –

c

• After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT

shield or carbon paint on the CRT.

• REMOVING PROCEDURES

1 Turn up one side of the rubber cap in the direction

indicated by the arrow a.

2 Using a thumb pull up the rubber cap firmly in the direc-

tion indicated by the arrow b.

3 When one side of the rubber cap is separated from the

anode button,  the anode-cap can be removed by
turning up the rubber cap and pulling it up in the
direction of the arrow c.

• HOW TO HANDLE AN ANODE-CAP

1 Do not damage the surface of anode-caps with

2 Do not press the rubber too hard so as not to

3 Do not turn the foot of rubber over too hard.

b

b

anode button

• Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom

right  and left.

1) Place the TV set with the CRT face down on a cushion jig.
2) Remove the rear cover.
3) Unplug all interconnecting leads from the Deflection yoke, Neck assy, Degaussing Coil and CRT grounding strap.

qs

 Earth Coating Assy

!∞ Block Center

4 Anode Cap Removal

!£ Band, DGC Removal

!§ Degaussing Coil

5 C6 Board Removal

9 Chassis Assy Removal

7 VM1 Board Removal

0 Support, CRT(2) Removal

qa

 Spring Tension(2) Removal

!¢ Holder, DGC(2) Removal

!¶ Nut, Special, CRT (4)

6 Loosen the Neck Assembly

fixing screw and removal

8 Loosen the Deflection Yoke

fixing screw and remove

a

a