KV-32XBR400 - Sony TV Service Manual (repair manual). Page 5

LOW B OCP/OVP
(overcurrent/overvoltage)
(see Note 3)

6 times

6:0 or 6:1

•  +5 line is overloaded. (A, B Boards)

•  +5 line is shorted.  (A, B Boards)

•  IC6007 is faulty. (A Board)

•  No picture

Horizontal Deflection
Stopped

7 times

7:0 or 7:1

•  No picture

*One flash count is not used for self-diagnostic.

Turn off the power switch on the TV main unit or unplug the power cord from the outlet to stop the STANDBY/STEREO LED from
flashing.

For errors with symptoms such as “power sometimes shuts off” or “screen sometimes goes out” that cannot be confirmed, it is
possible to bring up past occurrences of failure on the screen for confirmation.

In standby mode, press buttons on the Remote Commander sequentially, in rapid succession, as shown below:

Display

Channel 5

Sound volume

Note that this differs from entering the service mode (sound volume 

).

Power ON

+

SELF DIAGNOSTIC

2: +B OCP

0

3: +B OVP

0

4:  V STOP

0

5: AKB

1

6: LOWB

0

7:H-STOP

0

101: WDT

0

Numeral “0” means that no fault was detected.

Numeral “1” means a fault was detected one time only.

Note 1: If a +B overcurrent is detected, stoppage of the vertical deflection is detected simultaneously.

The symptom that is diagnosed first by the microcontroller is displayed on screen.

Note 2: Refer to Screen (G2) Adjustment in Section 3-4 of this manual.

Note 3: If STANDBY/STEREO LED flashes 6 times, unplug unit and wait ten seconds before performing

adjustment.

STANDBY/STEREO LED