Read Sony KV-21FS105 (serv.man2) Service Manual online
13
KV-21FS105
KV-21FS105
Dynamic Convergence Adjustment
Before performing this adjustment, perform Horizontal and Vertical Static
Convergence Adjustments.
Convergence Adjustments.
Preparation:
1. Slightly loosen defl ection yoke screw.
1. Slightly loosen defl ection yoke screw.
2. Remove defl ection yoke spacers.
3. Move the defl ection yoke for best convergence as shown:
R G B
B G R
R
G
G
B
R
G
B
B G R R G B
R G B
R
R
R
G
B
G
B
G
B
R G B
B G R
4 Tighten the defl ection yoke screw.
5. Install the defl ection yoke spacers.
TLH Plate Adjustment
Preparation:
1. Input crosshatch pattern.
1. Input crosshatch pattern.
2. Adjust PICTURE QUALITY to standard, PICTURE and BRIGHTNESS
to 50%, and OTHER to standard.
3. Adjust the Horizontal Convergence of red and blue dots by tilting the
TLH plate on the defl ection yoke.
TLH+
TLH-
TLH-
B R
(R)(B)
(R)(B)
R B
(B)(R)
(B)(R)
4. Adjust XCV core to balance X axis.
5. Adjust YCH VR to balance Y axis.
Screen-Corner Convergence
1. Affi x a permalloy assembly corresponding to the misconverged areas.
b
a
c
d
a
b
a-d: screen-corner
misconvergence
c
d
2-3. FOCUS
1. Adjust FOCUS control for best picture.
Focus (FV)
Screen (G2)
2-4. SCREEN (G2)
1. Input dot pattern from the pattern generator.
2. Set the PICTURE and BRIGHTNESS controls at minimum and
COLOR control at normal.
3. Adjust SBRT , GCUT, BCUT in service mode with an oscilloscope as
shown below so that voltages on the red, green, and blue cathodes
are 170 VDC.
are 170 VDC.
pedestal
GND
170Vdc
170 + 4.0 Vdc
4. Observe the screen and adjust SCREEN (G2) VR in FBT to obtain the
faintly visible background of dot signal.
Click on the first or last page to see other KV-21FS105 (serv.man2) service manuals if exist.