KP-57WV600, KP-57WV700, KP-65WV600, KP-65WV700 (serv.man5) - Sony TV Service Manual (repair manual). Page 2

Read Sony KP-57WV600 / KP-57WV700 / KP-65WV600 / KP-65WV700 (serv.man5) Service Manual online

— 
48 —
KP-57WV600/57WV700/
65WV600/65WV700
2-12. REGISTRATION  ADJUSTMENT 
 
(PJE MODE ONLY)
Change the
wide screen
mode
* When the 
NTSC Full mode
adjustment has finished,
copy its data to 
the zoom and 
HD full modes
the first time only 
and be sure to 
adjust in the order given.
See 2-13-2 (p. 52)
*ADJUSTING FLOW
START
Turn on the power and wait for 10 minutes.
Set to the NTSC Full mode
Check the deflection yokes, the centering magnets,
2 pole/4 pole magnets
Set to the service mode.
MAIN DEFLECTION ADJUSTMENT (Green)
Green coarse adjustment
Green fine adjustment
Red coarse adjustment
Red fine adjustment
Blue fine adjustment
Blue coarse adjustment
Memorize the FLASH FOCUS offset data
(Run flash focus in Service Mode)
End
Another wide screen mode?
DEFLECTION
SUB 
ADJUSTMENT
COPY*
Yes
No
2-12-1.SETUP FOR ADJUSTMENT
MARKING
•  At the 4 sides of the screen, locate the middle. Use a tape measure 
to identify the middle.
 
  
 
: middle
DATA SETTING
1. Set NTSC Full mode.
2. Enter the service mode, and select “PJE”.
NOTE: When you replace printed circuit boards or devices or CRTs, and 
when correction is drastically necessary, press the “7” + ENTER on the 
remote commander to initialize the data in the Projector Engine mode.
Press the MUTING + ENTER on the remote commander to write the 
data. 
2-12-2.MAIN DEFLECTION ADJUSTMENT
NOTE: Before this adjustment, refer to section 2-11 for PJE item #78-85 
input data.
1.  Cover the red and blue CRT lenses with lens caps to allow only green 
to show (or use the method shown in the note below for turning off the 
CRTs individually without using lens caps).
2.  Enter the monoscope signal and set to NTSC Full mode.
3.  Enter the service mode, and select “2170D-1”.
4.  Adjust “0 VPOS” and “1 VSIZ” so that the picture is displayed in the 
center of the screen.
5.  Adjust “2VSZ0” for 1080i vertical size adjustment.
0 VPOS
1 V-Size
6.  Select “2170D-2” and adjust “2 H-Size” so that the picture size is 
within the specifi cation.
2 H-Size
SPEC
Overscan Spec. = 9%
Input Signal
H SIZE
V SIZE
Monoscope
15.6 ± 0.2 sq.
11.5 ± 0.2 sq.
7.  Copy the data of the NTSC Full mode to the other wide screen mode 
and, if necessary, adjust in the other mode.
Page of 3
Display

Click on the first or last page to see other KP-57WV600 / KP-57WV700 / KP-65WV600 / KP-65WV700 (serv.man5) service manuals if exist.