Read Sony KLV-17HR2 Service Manual online
Approx. 459.9 x 363 x 89.4 mm
Approx. 5.1 kg (without stand)
LCD (Liquid Crystal Display) Panel
Depending on your country/region selection:
B/G/H, D/K, L, I
NTSC 3.58, 4.43 (only Video In)
75 ohm external terminal for VHF/UHF
including audio/video input, RGB input, TV
output, and SmartLink interface.
Y: 1 Vp-p, 75 ohms unbalanced, sync negative
C: 0.286 Vp-p (Burst signal), 75 ohms
1 Vp-p, 75 ohms unbalanced, sync negative
500 m Vrms (100% modulation)
Impedance: 47 kilohms
• Size AA batteries (R6 type) (2)
• Coaxial cable (1)
• Mains lead (Type C-6) (1)
• Mains lead (Type BF) (1)
• AC adaptor (AC-FD004E) (1)
supplied depending on the country/region.
• Sleep Timer
• SmartLink (Direct link between your TV and a
information on SmartLink, please refer to the
instruction manual of your VCR or DVD
• Auto Format
• NexTView (depending on availability of
and from all exposed metal parts to any exposed metal part
having a return to chassis, must not exceed 0.5 mA (500
Leakage current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or
use these instruments.
tion is 0.75 V, so analog meters must have an accurate low-
voltage scale. The Simpson 250 and Sanwa SH-63Trd are
examples of a passive VOMs that are suitable. Nearly all
battery operated digital multimeters that have a 2 V AC
range are suitable. (See Fig. A)
lowing safety checks before releasing the set to the customer:
1. Check the area of your repair for unsoldered or poorly-sol-
splashes and bridges.
certain that you have replaced all the insulators.
them out to the customer and recommend their replacement.
recommend their replacement.
your HV meter if sets always have low HV.
Leakage. Check leakage as described right.
Parts on Set
SAFE OPERATION. REPLACE THESE COMPONENTS
WITH SONY PARTS WHOSE PART NUMBERS AP-
PEAR AS SHOWN IN THIS MANUAL OR IN SUPPLE-
MENTS PUBLISHED BY SONY. CIRCUIT ADJUST-
MENTS THAT ARE CRITICAL FOR SAFE OPERATION
ARE IDENTIFIED IN THIS MANUAL. FOLLOW THESE
PROCEDURES WHENEVER CRITICAL COMPONENTS
ARE REPLACED OR IMPROPER OPERATION IS SUS-
LES COMPOSANTS IDENTIFIÉS PAR UNE TRAME ET
UNE MARQUE ! SONT CRITIQUES POUR LA
SÉCURITÉ. NE LES REMPLACER QUE PAR UNE
PIÈCE PORTANT LE NUMÉRO SPECIFIÉ. LES
RÉGLAGES DE CIRCUIT DONT L’IMPORTANCE EST
CRITIQUE POUR LA SÉCURITÉ DU
FONCTIONNEMENT SONT IDENTIFIÉS DANS LE
PRÉSENT MANUEL. SUIVRE CES PROCÉDURES
LORS DE CHAQUE REMPLACEMENT DE
COMPOSANTS CRITIQUES, OU LORSQU’UN
MAUVAIS FONCTIONNEMENT EST SUSPECTÉ.