Read Sony KDL-60W840B / KDL-60W850B / KDL-60W855B / KDL-60W857B / KDL-70W830B / KDL-70W840B / KDL-70W850B / KDL-70W855B / KDL-70W856B / KDL-70W857B Service Manual online
Chassis: RB2G, HE-H
Chassis: RB2G, HE-H
A-1
is a trademark of Sony Electronics
Sony Corporation
Sony LCSC
Technical Services
Service Publication Department
Reproduction in whole or part without written permission is prohibited. All rights reserved.
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential
information, and shall be handled under the non-disclosure obligations provided in the
applicable agreement with Sony Corporation (and/or its subsidiary).
information, and shall be handled under the non-disclosure obligations provided in the
applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit
Board containing encryption key components is repaired and/or replaced pursuant to
the following:
Board containing encryption key components is repaired and/or replaced pursuant to
the following:
1. In the service manual the Circuit Boards containing encryption key components
shall be identified with a red outline and a .
2. Only repair boards or components listed in the service manual shall be utilized for
replacement and/or repair.
3. Disassembly, decryption, or reverse-engineering components is strictly prohibited.
4. Any board in which the Servicer replaces an encryption key component must be
placed back into the set it orignally came from and the replaced defective component
MUST BE DESTROYED. Boards cannot be swapped.
MUST BE DESTROYED. Boards cannot be swapped.
5. If a Circuit Board identified with a red outline and a in the service manual is deemed
to be defective:
a. and if a core charge is imposed and is covered under the product warranty, the
defective un-repaired or modified board MUST BE RETURNED to Sony.
b. and if the core charge is NOT covered under the product warranty, the defective
un-repaired or modified board MUST BE DESTROYED.
6. If a unit is destroyed (such as field scrap), the Circuit Board identified with a
red outline and a in the service manual MUST BE DESTROYED.
9-883-585-51
English
2012CJ74WEB-1
Printed in USA
© 2015.2
