Read Sony KDL-40HX805 / KDL-46HX805 Service Manual online
KDL-40HX805/46HX805
24
SERVICE ADJUSTMENTS
2-4. CHANGE THE EMITTER OUTPUT LEVEL
Note: To reduce the emitter LED output power strength.
Change Data of “PEM” service mode.
a. To select 009 3D, press
2
then
5
on the remote.
b. To select 000 EMIT_STR, press
1
then
4
on the remote.
c. To change data from “0” to “1” press
3
then
6
on the
remote.
0: Strong (Default)
1: Weak
d. Save and reboot.
PEM
SERVICE
009
000
EMIT_STR
3D
1
2-5. RESETTING THE TV TO FACTORY CONDITION
Use the following instructions to restore the User Adjustments
and Channel Memory settings to the preset factory conditions.
1. While holding down the on the Remote Commander,
press the POWER button on the TV Switch Unit of the set.
The set restarts and displays the Initial Setup screen. This
may take several minutes.
2-5-1. RESETTING THE TV TO FACTORY CONDITION USING
SERVICE MODE
1. TV must be in Standby Mode. (POWER off).
2. Press the following buttons on the Remote Commander
within a second of each other:
DISPLAY
Channel
5
Volume
+
POWER
.
3. If necessary, press
JUMP or OPTIONS to go to DIGITAL
mode.
4. Press
8
.
“SERVICE” changes to green RST.
5. Press MUTING.
RST executes the command and displays EXE.
6. Press
0
.
EXE-RST displays green, then red indicating the TV is
writing the data.
7. When the process is complete the green SERVICE text
displays and the LED display as shown below:
TIMER
Standby
POWER
TIMER
Standby
POWER
8. Cycle AC Power (Unplug and Plug AC Cord from the AC
Outlet).
9. The set restarts and displays the Initial Setup screen.
This may take several minutes.
Click on the first or last page to see other KDL-40HX805 / KDL-46HX805 service manuals if exist.