KDL-40EX1, KDL-46EX1, KDL-52EX1 - Sony TV Service Manual (repair manual). Page 6

Read Sony KDL-40EX1 / KDL-46EX1 / KDL-52EX1 Service Manual online

KDL-40/46/52EX1 (AUS/NZ)     5
WARNING!!
An isolation transformer should be used during any service to
avoid possible shock hazard, because of live chassis.
The chassis of this receiver is directly connected to the ac power
line.
!
 
SAFETY-RELATED COMPONENT
WARNING!!
Replace all components with Sony parts whose part numbers
appear as shown in this manual or in supplements
published by Sony.
WARNINGS
SAFETY-RELATED COMPONENT
WARNING
It is essential that all critical parts be replaced only with the part
number specified in the electrical parts list to prevent electric
shock, fire, or other hazard.
NOTE: Do  not modify the original design without obtaining
written permission from the manufacturer or you will
void the original parts and labor guarantee.
USE CAUTION WHEN HANDLING THE LCD PANEL
When repairing the LCD panel, be sure you are grounded by
using a wrist band.
When repairing the LCD panel on the wall, the LCD panel must
be secured using the 4 mounting holes on the rear cover.
1) Do not press on the panel or frame edge to avoid the risk of
electric shock.
2) Do not scratch or press on the panel with any sharp objects.
3) Do not leave the module in high temperatures or in areas of
high humidity for an extended period of time.
4) Do not expose the LCD panel to direct sunlight.
5) Avoid contact with water. It may cause a short circuit within
the module.
6) Disconnect the AC power when replacing the backlight (CCFL)
or inverter circuit.
(High voltage occurs at the inverter circuit at 650Vrms.)
7) Always clean the LCD panel with a soft cloth material.
8) Use care when handling the wires or connectors of the inverter
circuit. Damaging the wires may cause a short.
9) Protect the panel from ESD to avoid damaging the electronic
circuit (C-MOS).
CAUTION
1. XA CONNECTOR ATTACHMENT
Note: After the XA connector is attached, confirm the housing
edge and connector edge are in the same position as in
“LOCKED SITUATION”.
< UNLOCK SITUATION >
Housing and Connector 
edge are not flush.
Housing and Connector 
edge are flush
.
< LOCK SITUATION >
Page of 70
Display

Click on the first or last page to see other KDL-40EX1 / KDL-46EX1 / KDL-52EX1 service manuals if exist.