Read Sony KDL-32XBR6 / KDL-37XBR6 Service Manual online
18
KDL-32XBR6/37XBR6
KDL-32XBR6/37XBR6
SHIELD REMOVAL
BALANCER (ETC-INVERTER) BOARD REMOVAL
WARNING
NEVER REMOVE THE
SCREWS SECURING THE
PLASTIC STRIP HOLDING
PLASTIC STRIP HOLDING
THE LAMP SOCKETS
DAMAGE TO THE
BACKLIGHT TUBES WILL
Only remove the screws securing the inverter
cover which may be metal or plastic. The
remaining plastic strip contains sockets for the
fluorescent backlights and should never be
loosened. The backlights will pop out of the
sockets and/or break the backlight requiring a
LCD panel replacement.
REMOVE SCREWS
SECURING
SHIELD
REMOVE
CONNECTOR AND
PULL BOARD TO
THE RIGHT
!
.
OCCUR!
BACKLIGHT
END VIEW
SOCKET
1-9. ETC- INVERTER MT BOARD REMOVAL (KDL-32XBR6 ONLY)
1 Remove 5 screws from Board Cover.
2 Pull out the Board from Lamp socket
2 Pull out the Board from Lamp socket
Balancer
(ETC- Inverter MT) Board
(ETC- Inverter MT) Board
1
2
Inverter Board Cover
Plastic Strip
holding
Lamp Socket
holding
Lamp Socket
DO NOT
REMOVE
BACKLIGHT
SCREWS
REMOVE
BACKLIGHT
SCREWS
Balancer
(ETC- Inverter MT) Board
(ETC- Inverter MT) Board
LCD Panel
NOTE: The LVDS cable can only be installed one way. There is colored tape on the cable to determine which side is attached
to the TCON and which side is attached to the BU Board. Refer to Wire Dressing Illustration “Installation Procedure”
on Page 34.
Click on the first or last page to see other KDL-32XBR6 / KDL-37XBR6 service manuals if exist.