KDL-26S5550, KDL-32S5550 - Sony TV Service Manual (repair manual). Page 16

The TT modes described below are available by selecting the two 
relevant digits. You can exit the ‘TT Mode’ by entering 00, by
pressing the ‘Analog’ or the ‘Digital’ button, by switching  the TV 
set into Stand-by mode, or by Powering the TV set off.

'TT' mode off

Set volume to 35%

Set volume to 50%

Set volume to 65%

Set volume to 80%

Ageing mode on

Shipping Condition

WB Levels Check

Panel_id A

Panel_id B

Speaker_id A

Speaker_id B

Factory toggle mode (ON/OFF)

CBA mode toggle (ON/OFF)

ECS mode toggle (ON/OFF)

Set DVB-T channel table

Set DVB-C channel table

Full HD HDMI EDID Write

WXGA HDMI EDID Write

Re-initialise NVM

Select Dual Sound "A"

Select Dual Sound "B"

Select Dual Sound "Mono"

Select Dual Sound "Stereo"

Set NVM as non-virgin

Set NVM as virgin

Set KDL-32S5550

Set KDL-26S5550

WXGA /FHD Panel Selection

Set Centred Balance

Set Volume to Max

Set Volume to Min

Set Balance Full Left

Set Balance Full Right

Digital BER Display

TS CI Path Through

Front Panel Button Test

LED Test

TS CI Path Through With Reed Solomon Off



To place the Remote Commander in ‘TT Mode’ press the

 

following buttons together for approximately five seconds.



To use the Remote Commander in ‘TT Mode’ press the

 

‘Red’ text button on the Remote Commander twice.

 

TT will then appear in the bottom right hand corner of the TV.

i+

5

+

(ON SCREEN (DIGIT 5) (VOLUME +) (TV)
DISPLAY)



To take the Remote Commander out of ‘TT Mode’ press the

 

same buttons together for approximately five seconds.

TT Button