Read Sony FDL-250T Service Manual online
– 4 –
D
Using with Video Equipment (see fig.
D
)
Connect video equipment (such as VCR or camcorder) to the unit using an audio/video cable
(miniplug
(miniplug
y phono plug) (not supplied).
When you connect an audio/video cable to the unit, the unit automatically selects the input only
from the video equipment.
After connecting, start playback on the video equipment connected to the unit.
from the video equipment.
After connecting, start playback on the video equipment connected to the unit.
About the A/V IN jack
The A/V IN jack is a minijack, and the signal connections are aligned as shown on the left. This
alignment may be opposite depending on the equipment.
In such case (if no sound is heard and no picture is seen), connect the video plug to the audio
output jack, and the audio plug to the video output jack of the equipment.
alignment may be opposite depending on the equipment.
In such case (if no sound is heard and no picture is seen), connect the video plug to the audio
output jack, and the audio plug to the video output jack of the equipment.
To A/V IN
Camcorder
VCR
To video output
To audio output
AUDIO
VIDEO
English
English
Precautions
•
Use the recommended Sony AC power adaptor,
AC-E45HG (not supplied). Do not use any other type of
AC power adaptors for this unit.
AC power adaptors for this unit.
• Do not open the unit. Refer servicing to qualified
personnel only.
• Do not place the unit in a hot or humid place, or in a place
subject to excessive dust or vibration.
• Avoid rough handling.
• Clean the unit with a soft cloth slightly dampened with a
• Clean the unit with a soft cloth slightly dampened with a
mild detergent solution. Never use strong solvents, such as
thinner or benzine, as they may damage the finish.
thinner or benzine, as they may damage the finish.
• Do not touch the AC power adaptor with wet hands. Doing
so may cause an electric shock.
• Do not touch the external antenna cord or AC power
adaptor during stormy weather. Doing so may result in an
electric shock.
electric shock.
• Do not use while driving, walking or engaging in any
activity where full attention is required.
• Keep out of reach of children. Strap antenna could cause
strangulation.
• When opening the display, be careful not to pinch your
fingers in the hinge. Also, be careful that the sunshade
does not close on your fingers while viewing.
does not close on your fingers while viewing.
Troubleshooting
B
efore you contact your nearest Sony dealer or authorized
service center, refer to the following troubleshooting guide.
No picture, no sound
• The AC power adaptor is disconnected.
• Incorrect battery polarity.
• Weak batteries. Replace all the batteries with new ones.
• The external antenna is disconnected.
• The video equipment is not connected properly.
• Incorrect battery polarity.
• Weak batteries. Replace all the batteries with new ones.
• The external antenna is disconnected.
• The video equipment is not connected properly.
Good picture, no sound
• Turn the VOL dial to the + direction.
• The headphones are connected.
• Weak batteries. Replace all the batteries with new ones.
• The video equipment is not connected properly.
• The headphones are connected.
• Weak batteries. Replace all the batteries with new ones.
• The video equipment is not connected properly.
Good sound, no picture
• Weak batteries. Replace all the batteries with new ones.
• Increase the brightness by turning the BRT dial toward the
• Increase the brightness by turning the BRT dial toward the
+ direction.
• The video equipment is not connected properly.
Snowy or indistinct picture
• Improper tuning.
• Extend the strap antenna fully.
• Adjust the strap antenna direction.
• Connect an external antenna (not supplied).
• Extend the strap antenna fully.
• Adjust the strap antenna direction.
• Connect an external antenna (not supplied).
Dotted lines or stripes
Often caused by interference from other electrical appliances
such as a hair dryer, car, or motorcycle.
• Relocate the strap antenna away from the source of
such as a hair dryer, car, or motorcycle.
• Relocate the strap antenna away from the source of
interference.
• Extend the strap antenna fully.
• Connect an external antenna (not supplied).
• Connect an external antenna (not supplied).
WARNING
To prevent fire or shock hazard, do not expose the unit to
rain or moisture.
This symbol is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product
presence of uninsulated “dangerous voltage” within the
product
’
s enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature accompanying
the appliance.
presence of important operating and maintenance
(servicing) instructions in the literature accompanying
the appliance.
CAUTION
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
approved in this manual could void your authority to operate this
equipment.
Owner's Record
The model and serial numbers are located at the front side. Record the
serial number in the space provided below. Refer to these numbers
whenever you call upon your Sony dealer regarding this product.
Model No. FDL-250T Serial No.
serial number in the space provided below. Refer to these numbers
whenever you call upon your Sony dealer regarding this product.
Model No. FDL-250T Serial No.
Click on the first or last page to see other FDL-250T service manuals if exist.