RM-PJM10, VPL-CS2, VPL-CX1 - Sony Projector Service Manual (repair manual). Page 13

1-8

VPL-CS2/CX1

GB 

14

Location and Function of Controls

qa

Functions as the left button on a mouse.

qs

qd

qf

Cut off the picture.  Press again to 
restore the picture.

qg

– keys

qh

Push and slide to open the lid, then 
install the two size AA (R6) batteries 
(supplied) with the correct polarity.

Replace the lid.

• Make sure that the battery orientation is 

correct when inserting batteries.

• Do not mix an old battery with a new one 

or different types of batteries. 

• If you do not use the Remote Commander 

for a long time, remove the batteries to 
avoid damage from battery leakage. If 
batteries have leaked, remove them, wipe 
and dry the battery compartment, and 
replace the batteries with new ones. 

• Make sure that nothing obstructs the 

infrared beam between the Remote 
Commander and the remote control 
detector on the projector. Direct the 
Remote Commander toward the front or 
rear remote control detector.

• The operation range is limited. The shorter 

the distance between the Remote 
Commander and the projector is, the wider 
the angle within which the commander can 
control the projector becomes. 

Be sure to install 
the battery from 
the 

#

 side.

15

 GB

Installing the Projector

Sett

ing Up

 a

n

d Proj

ect
in

g

B

This section describes how to install the projector.
The distance between the lens and the screen varies depending on the size of 
the screen. Use the following table as a guide. 

 

You can not install the projector upside down, such as on a ceiling.

Unit: m (feet)

1.6 

(5.2)

2.4 

(7.8)

3.2 

(10.5)

4.0 

(13.2)

4.9

(15.9)

6.1 

(20.0)

2.0 

(6.6)

3.1

(10.0)

4.1

 (13.5)

5.2

 (16.9)

6.2

(20.3)

7.8

(25.5)

Distance between the screen and 
the center of the lens