DPP-M55 (serv.man2) - Sony Other Service Manuals Service Manual (repair manual). Page 5

Read Sony DPP-M55 (serv.man2) Service Manual online

— 5 —
(Note) Direction of printing during face-to-face shooting
When printing from DSC-F1, data on angle of rotation of the image will not be transferred. Consequently, images shot by
face-to-face shooting (shooting with the camera rotated) will be opposite the printing direction.
(See Fig. 3)
Even if the images are rotated in DSC-F1, the printing direction will not change.
In this case, change the direction of inserting the print paper into DPP-M55, or input the images to the PC, rotate the
images, and then print.
Fig. 3 Direction of Printing
(v) Transfer of image data
DPP-M55 is always in the data reception mode while the data transmission indicator is lit.
(a)
Switching of Input
DPP-M55 has the following three input terminals.
W IrDA terminal
W DOS/V PC cable terminal
W Macintosh cable terminal
When a signal input is detected, the input destination is switched automatically. While the signal from one input terminal
is being read, the other pin inputs will be ignored.
Consequently, the DOS/V and MAC cable terminals can be used at a time without any problems.
(b)
IrDA
When the IrDA signal from DSC-F1 is received, a short beep is sounded once, and reading of the image data starts.
W If the signal from DSC-F1 cannot be received by DPP-M55, “Print Error” is displayed on the DSC-F1 LCD
about 50 seconds after data transmission starts.
One image takes about 85 seconds to transfer.
When one image data is read on DPP-M55, a long beep is sounded once, and printing starts.
W If an error generates during the transfer of image data, that data is re-transferred from DSC-F1. Consequently, if
no long beep is sounded about 85 seconds later, it means that an error occurred during data transfer, and the data
transfer state must be corrected.
(Important) Data transmission to the DSC-F1
Image data can be transmitted from DSC-F1 to PC via DPP-M55. However, Image data can not be transmitted from PC
to DSC-F1 via the DPP-M55.
To transmit image data from PC to the DSC-F1, connect PC to DSC-F1 directly.
Page of 14
Display

Click on the first or last page to see other DPP-M55 (serv.man2) service manuals if exist.