DPP-FP95 - Sony Other Service Manuals Service Manual (repair manual). Page 13

3-1

DPP-FP95

When replacing MAI board, be sure to write the latest firmware.
For detail, refer to “3-2-3. FIRMWARE WRITING AND VERSION
UPGRADE”.
When writing of the latest firmware and version upgrade is completed,
be sure to delete the old driver and to install the driver newly again.

When replacing the thermal printer (MD) and MAI board, be sure
to adjust the density.
For detail, refer to Section 3-2-1.

When replacing the LCD, be sure to LCD contrast can be adjusted
and the color display can be check using the service mode as follows.
For detail, refer to Section 3-2-2.

When replacing main parts, adjust the items indicated by z in the
following table.

* If destination is changed after version upgrade is

completed, execute both items of destination change
and LCD contrast adjustment (VCOM).

The changed portions from
Ver. 1.0 are shown in blue.

Density adjustment

LCD contrast adjustment (VCOM),
Color display check

Firmware writing and version upgrade

Setting of destination

Fan operation check

Button operation check

LED operation check

Tray sensor operation check

Ribbon sensor operation check

Image reading check from memory card

(MS, MSDuo, SD, XD, CF)

USB host/device communication check

Output confirmation of HDMI

Confirmation by print usually

CHECKSUM check

Refer to page 3-5 “Check and adjustment

upon completion of version upgrade”

About the error indication

Mechanical operation check

3-2-1

3-2-2

3-2-3

3-2-4

3-3-1

3-3-2

3-3-3

3-3-4

3-3-5

–

3-2-3

3-3-6

3-3-7

LCD replacement

MD replacement

MAI board replacement

KEY board replacement

Firmware version upgrade

Main Parts

Replacement

z z

z

z

*

z

z

*

z z

z z

z

z z

z z

z

z

z

z z z

z

Optional

Optional

Adjustment

Items

Check

Items