Read Sony DPP-F800 Service Manual online
DPP-F800
2-1E
2. ASSEMBLY
LCD metal
frame edge
frame edge
0 to 3.9 mm
0 to 11 mm
LCD metal
frame edge
frame edge
0 to 6.9 mm
0 to 5.8 mm
0 to 12 mm
LCD Sponge L
LCD Sponge L
LCD Sponge S
LCD Sponge S
LCD Assy
Assembly-1: Putting position of the LCD Sponge S
and the LCD Sponge L
Label side
Top Cover Assy
DC Fan
Tighten the screw without involving the harness.
Assembly-3: Method for attaching of the DC Fan
Slot
Put the DC Fan in the frame on the Top Cover Assy with
the label side downward and pass the harness through
the slot, then tighten two screws without involving the
harness.
the label side downward and pass the harness through
the slot, then tighten two screws without involving the
harness.
LCD Assy
Rear Cover Assy
Assembly-2: Routing the LCD Assy harness
Routing outside the rib
Route the LCD Assy harness outside the ribs of
the Rear Cover Assy without being wedged under
the LCD Assy.
the Rear Cover Assy without being wedged under
the LCD Assy.
Harness
Bottom Cover
Thermal Printer Assy
Assembly-4: Method for installing
the Thermal Printer Assy
Install the Thermal Printer Assy into the Bottom Cover
while sliding it in the direction indicated with arrow as
shown below.
while sliding it in the direction indicated with arrow as
shown below.
Cable of the DC IN Board Assy
Bottom Cover
Downmost
Uppermost
Claw
Assembly-5: Routing the cable and harnesses
Note: The arrangement of the cable, flexible board and
harnesses is important that will affect routing
operation in the post process.
Especially, the cable of the DC IN Board Assy
should be arranged from the downmost position
to the uppermost position as shown below.
operation in the post process.
Especially, the cable of the DC IN Board Assy
should be arranged from the downmost position
to the uppermost position as shown below.
5-1. Pass the cable of the DC IN Board Assy through the
guide indicated with arrow.
5-2. Arrange the cable, flexible board and harnesses
as shown below.
5-3. Hook the thin color harnesses together on the claw
and pass them inside the guide indicated with arrow.
Cable of the
DC IN Board Assy
DC IN Board Assy
5-4. Hook the cable of DC IN Board Assy on the claw of
the Rear Cover Assy.
5-5. Turn over the Main PWB Assy to attach it to the Rear
Cover Assy and pass the cable of the DC IN Board
Assy outside the guide 1 and inside the guide 2
indicated with arrow.
Assy outside the guide 1 and inside the guide 2
indicated with arrow.
Claw
Cable of the
DC IN Board Assy
DC IN Board Assy
DC IN Board Assy
Rear Cover Assy
2
1
Click on the first or last page to see other DPP-F800 service manuals if exist.