MHS-TS55 - Sony Movie Service Manual (repair manual). Page 10

MHS-TS55

3-1E

Assembly-1: Installation Cautions of the Rear

Cover Assy.

Route the Speaker harness and USB harness.

Soldering position

Speaker

harness

USB

harness

USB

harness

Soldering position

Speaker harness

Assembly-3: Installation Cautions of the USB

Terminal Assy.

When installing the USB Terminal Assy, 
install it with angle less than 90 degrees as shown in the figure below.

90

USB Terminal Assy

Assembly-2: Installation Cautions of the Sub

Board Attachment.

The fusing point of the cover of Sub Board Attachment is low. 
Therefore, be careful not to damage the Sub Board Attachment when soldering. 

Soldering position

Soldering position

Six Harnesses

Lands

(solder)

Main Board Assy

1
2
3
4
5
6

1 2 3 4 5 6

Sub Board Assy

Main Board Assy

Sub Board Attachment

If it is hard to solder the Sub Board Attachment,
use 6 pieces of commercially available harness. 
In case of using the commercially available harnesses,
solder them as shown in the figure below.

1

3

4

5

2

Method of disassembling of the Top Cover

HDMI Cover

Screws

Claw

Top Cover

Top Cover

Top Cover

Top Cover

Open the HDMI cover and remove
two screws. 

Pull out the long leg while shifting a little the long leg of top cover right. 

Rotate the top cover about 90 degrees. 

Lift up the long leg of top cover and remove the short leg. 

Even if the long leg is
straightly pulled up,
it cannot be pulled out.

long leg

long
leg

long leg

short leg

Unlock the claw in the
center of top cover.

NG

The changed portions from
Ver. 1.0 are shown in blue.