HDR-XR100, HDR-XR100E, HDR-XR101, HDR-XR105E, HDR-XR106E, HDR-XR200, HDR-XR200E, HDR-XR200V, HDR-XR200VE (serv.man2) - Sony Movie Service Manual (repair manual). Page 27

2-1

HDR-XR100/XR100E/XR101/XR105E/XR106E/XR200/XR200E/XR200V/XR200VE_L2

Cut and remove the part of gilt 
which comes off at the point.
(Be careful or some 
pieces of gilt may be left inside) 

• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.

Do not insert the cable insufficiently nor crookedly.

• When remove a connector, don’t pull at wire of connector. It is possible that a wire is snapped.

• When installing a connector, don’t press down at wire of connector.

It is possible that a wire is snapped.

The charging capacitor (C5008) of ST-206 board is charged up
to the maximum 330 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand.  The electric shock is caused by
the charged voltage which is kept without discharging when the
main power of the unit is simply turned off.  Therefore, the
remaining voltage must be discharged as described below.

1 k

Ω

/1 W

Wrap insulating tape.

ST-206 Board

Note: High-voltage cautions

Discharging the Capacitor
Short-circuit between the two points 
with the short jig about 10 seconds.

R:1 k

Ω

/1 W

(Part code: 1-215-869-11)

FP-1016 
Flexible 
Board

There are discharging points under 
the FP-1016 flexible board.

To preparing the short jig, a small clip is attached to each end of
a resistor of 1 k

Ω /1 W (1-215-869-11).

Wrap insulating tape fully around the leads of the resistor to
prevent electrical shock.