Read Sony HDR-SR11 / HDR-SR11E / HDR-SR12 / HDR-SR12E (serv.man2) Service Manual online
1-3
ENGLISH
JAPANESE
ENGLISH
JAPANESE
HDR-SR11/SR11E/SR12/SR12E_L2
1-3. METHOD OF COPING WITH SHIFT LENS ERROR
about 330 msec
Fig. 2
Change in output voltage of R5549 on the LD-230 board
Note: The length of low section will vary a little depending on the
conditions.
1-3-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
Procedure
1
Turn the power OFF.
2
While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501 on the LD-230 board, turn the
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
3
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
the camera control circuit (IC1301 of VC-516 board) periphery.
the camera control circuit (IC1301 of VC-516 board) periphery.
Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
handheld operation.
VC-516 BOARD (SIDE A)
LD-230 BOARD (SIDE A)
IC5501
R5534
R5549
R5526
C5513
4
R5525
31
R5538
R5549: No Mount
(Short Land)
(Short Land)
IC1301
Fig. 1
Measurement points on the LD-230 board and the VC-516 board
Click on the first or last page to see other HDR-SR11 / HDR-SR11E / HDR-SR12 / HDR-SR12E (serv.man2) service manuals if exist.