HDR-CX190, HDR-CX190E, HDR-CX200, HDR-CX200E, HDR-CX210, HDR-CX210E, HDR-PJ200, HDR-PJ200E, HDR-PJ210 (serv.man2) - Sony Movie Service Manual (repair manual). Page 5

HDR-CX190/CX190E/CX200/CX200E/CX210/CX210E/PJ200/PJ200E/PJ210_L2

1-1

In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4 V), the power is shut off 
so that the unit cannot operate.
These following method is available to prevent this.

Use the AC power adaptor.

Note the following when replacing the board.

Note:  When replacing the board, it is necessary to change the destination data first. 
 

To change the destination data, execute the [DESTINATION DATA WRITE] of ADJUST tab in the Adjust Manual.

When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the “DESTINATON DATA WRITE”.
After the board replacement, the error of the built-in recording media may be displayed. In this case, execute the [DESTINATION DATA WRITE]
then the error will be cleared. If it is not cleared with [DESTINATION DATA WRITE], format the built-in recording media.

When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform “USB SERIAL SAVE” to get the data.

The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the “USB SERIAL No. INPUT”.

Before replacing the board with a spare board, acquire the following data from the current board.
•  Fixed value (that shows irradiation performance of the projector).
•  Serial number of the projector unit.
To acquire the data, start Adjust Manual from Adjust Station and select [Projector Data Reference] on the [DATA] tab.

After the board replacement, execute the procedure below first.
1.  Execute the [DESTINATION DATA WRITE] of ADJUST tab in the Adjust Manual.
2.  Execute the script files below. (Refer to the flowchart in Fig. 1)

• 11DdmMmcReadTestMINI_v4.vbe
• 11DdmMmcMakePartition_v4.vbe

Note:  Download the script files from TISS Homepage.
 

When searching in the TISS Homepage, enter “IM_VC_TOOL” for keyword in the Part Number field.

Unless these script files are executed, the following symptoms may appear.
Make sure execute the above script files.
•  The internal memory is not recognized as a media.
•  The management file saved in the internal memory model cannot be repaired.
•  The internal memory cannot be formatted.

START

END

Reactive the camcorder automatically

Disconnect the USB cable,

 and turnoff the power switch.

Select the "USB CONNECT" to establish 

the connection

Execute 

the "DdmMmcReadTestMINI.vbe"

(several second)

Wait until "SetOverallReadMINI OK" display

Reactive the camcorder automatically

Execute

 the "11DdmMMCMakePartition.vbe"

(several second)

Wait until "MakePartition OK" display

During the power is turning-on,

 pull-out the AC-adapter. 

Then connect the AC-adapter Again 

(It's running with blue color monitor.)

Connect to the PC with a USB cable, 

and turn on the power switch.

* by SEUS driver