HDR-AS10, HDR-AS15 (serv.man2) - Sony Movie Service Manual (repair manual). Page 4

1-1

HDR-AS10/AS15_L2

Note the following when replacing the board.

When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the “DESTINATON DATA WRITE”.
After the board replacement, the error of the built-in recording media may be displayed. In this case, execute the “DESTINATION DATA WRITE”
then the error will be cleared. If it is not cleared with “DESTINATION DATA WRITE”, format the built-in recording media.

When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform “USB SERIAL SAVE” to get the data.

The unit is shipped after an ID (PRODUCT ID) unique to each model has been written.
This ID is not written to a new replacement board. Enter a unique ID after the board has been replaced.
Start the Adjust Manual in the Adjust Station and execute the “PRODUCT ID & USB SERIAL No. INPUT”.

The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the “USB SERIAL No. INPUT”.

No PRODUCT ID is set for a new replacement board.
Therefore, if the board is replaced with a new replacement board, a discrepancy with the user-registered PRODUCT ID provided by the customer 
may be generated.
After the board has been replaced with a new replacement board, start Adjust Manual from Adjust Station and execute “PRODUCT ID & USB SE-
RIAL No. INPUT”.

Perform the following procedure after replacement to the repairing board.
1.  Execute “Wireless LAN check” in the Adjust Manual.

If “Wireless LAN check” is not executed and the backup data before replacement is restored, the MAC address in the Wi-Fi module does not match 
the MAC address in the flash memory, causing an error during Wi-Fi transfer.

A password required for Wi-Fi connection is recorded in every repairing board.
A label to present the password to the customer is stuck to every repairing board.
When a repairing board is replaced, attach this label to the unit to be sent back.

Note: 

The password can be checked on the PC connected to the unit with a USB cable.

 [PMHOME] 

→ [INFO] → [WIFI_INF.TXT]

The handbook PDF is stored in the internal memory of the repairing board.
The data of this handbook PDF differs depending on destinations.

If the Destination Data file included in the Adjust manual is old, “DESTINATION DATA WRITE” cannot be executed in some cases.
In that case, download a new Destination Data file from the TISS homepage according to the following procedure.

Note 1:  To perform Destination Data Write for this model, the Adjust manual of the DSC-WX50 series must have been installed.
 

Install the Adjust manual of the DSC-WX50 series in advance.

Note 2:  The actual image may differ from the image shown above.

1)  If the Destination Data file in the Adjust manual in use is old, the window shown in Fig. 1 is displayed.
 

Click the [OK] button.

2)  The Destination Data Write window opens.
 

Check the version of the Destination Data file retained in the Adjust manual.

Destination Ver. window

The changed portions from
Ver. 1.1 are shown in blue.