Read Sony DEV-30 / DEV-50 / DEV-50V (serv.man2) Service Manual online
DEV-30/50/50V_L2
3-1E
3. ASSEMBLY
Assembly-1: Notes on Assembling the JKL Block Assy.
Groove
DC-IN Harness
Harness of the
Speaker (1.6CM)
Speaker (1.6CM)
Groove
Route these harnesses.
Assembly-2: How to distinguish the side of Optical Filter
Block facing to Lens Device
Lens Device side
Hold it with tweezers
or the like.
or the like.
Hold it with tweezers
or the like.
or the like.
This IR coated optical filter block has side A and side B.
When the optical filter block is exposed to fluorescent light at
a place where environmental light is blocked, side A glow red
and side B glow white at certain angles.
Install the optical filter block with side B facing toward the lens.
When the optical filter block is exposed to fluorescent light at
a place where environmental light is blocked, side A glow red
and side B glow white at certain angles.
Install the optical filter block with side B facing toward the lens.
Optical
Filter
Block
Filter
Block
Optical
Filter
Block
Filter
Block
Glow white at certain angles.
Glow red at certain angles.
[IR Cut Coated Side A]
[IR Cut Coated Side B]
NG
Lens
F inner section,
F outer block assy
F outer block assy
Do not hold the following part.
OK
Must not put the lens block (CG001)
turning lens downward.
turning lens downward.
CAUTION FOR HANDLING
THE LENS BLOCK (CG001)
THE LENS BLOCK (CG001)
Very weak
Very weak
Very weak
Very weak
Downward
Downward
Assembly-3: Notes on Assembling the BT Lid Block Assy
BT Lid Block Assy
(1) Insert the BT Lid Shaft to the BT Lid Block Assy.
(3) Close the BT Lid Block Assy and check that the BT Lid Spring
is engaged with the groove.
is engaged with the groove.
(2) Insert the BT Lid Hinge Base (R) into the hole in the BT Lid Shaft.
At the same time, insert the BT Lid Spring into the groove
while maintaining it at the position shown in the figure with
tweezers or the like.
At the same time, insert the BT Lid Spring into the groove
while maintaining it at the position shown in the figure with
tweezers or the like.
(4) Install the BT Lid Hinge Base (L), and tighten with the screw.
BT Lid Shaft
Hole of the BT Lid Hinge Base (R)
BT Lid Hinge
Base (L)
Base (L)
Screw
BT Lid Block Assy
BT Lid Spring
BT Lid Spring
BT Lid Spring
Groove
Groove
Tweezers