Read Sony DCR-TRV820 / DCR-TRV820E / DCR-TRV820P Service Manual online
– 8 –
3.
NOTE FOR REPAIR
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
When remove a connector, don’t pull at wire of connector.
It is possible that a wire is snapped.
It is possible that a wire is snapped.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some pieces of
gilt may be left inside)
which comes off at the point.
(Be careful or some pieces of
gilt may be left inside)
When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
It is possible that a wire is snapped.
4.
LCD TYPE CHECK
By measuring the resistor value between Pin 6 of CN5502 and
Pin 0 of CN5502 on PD-118 board, the type of LCD can be dis-
criminated.
Pin 0 of CN5502 on PD-118 board, the type of LCD can be dis-
criminated.
Note:
About PD-118 board and LCD module, discriminate LCD
type on the machine, and replace the same type.
type on the machine, and replace the same type.
PD-118 board CN5502
Resistor
LCD type
PD board
value
8.2 k
Ω
TYPE S
PD-118 (TYPE S)
10 k
Ω
TYPE C
PD-118 (TYPE C)
Multi CPC jig
(J-6082-311-A)
(J-6082-311-A)
CN5502
Volt ohm meter
PD-118 board
6
pin
0
pin
Click on the first or last page to see other DCR-TRV820 / DCR-TRV820E / DCR-TRV820P service manuals if exist.