Read Sony DCR-TRV410E / DCR-TRV510E Service Manual online
— 4 —
SERVICE NOTE
1.
POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied (8.4V) to the
battery terminal using the service power cord (J-6082-223-A), the
power is shut off so that the unit cannot operate.
This following three methods are available to prevent this. Take
note of which to use during repairs.
battery terminal using the service power cord (J-6082-223-A), the
power is shut off so that the unit cannot operate.
This following three methods are available to prevent this. Take
note of which to use during repairs.
Method 1.
Connect the servicing remote commander RM-95 (J-6082-053-B)
to the LANC jack, and set the remote commander switch to the
“ADJ” side.
to the LANC jack, and set the remote commander switch to the
“ADJ” side.
Method 2.
Press the battery switch of the battery terminal using adhesive tape,
etc.
etc.
Method 3.
Use the DC IN terminal. (Use the AC power adaptor.)
7
Pull the timing belt in the direction of
arrow
arrow
A
with a pincette while pressing
the cassette lid (take care not to damage)
to adjust the bending of a tape.
to adjust the bending of a tape.
8
Let go your hold the cassette
lid and rise the cassette
compartment to take out a cassette.
lid and rise the cassette
compartment to take out a cassette.
Pincette
Timing belt
Timing belt
Press the cassette lid to rise
the cassette compartment
the cassette compartment
[DC power supply]
(+5V)
Adjust the bending of a tape
Disconnect CN901
of VC-213 board.
of VC-213 board.
Loading motor
DC IN terminal
Battery switch
Battery terminal
’
Battery terminal
‘
Battery SIG terminal
2.
TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1 Refer to 2-2. to remove the front panel assembly.
2 Refer to 2-2. to remove the cabinet (R) assembly.
3 Refer to 2-6. to remove the battery panel assembly.
4 Refer to 2-8. to remove the cabinet (L) assembly.
5 Disconnect CN901 of VC-213 board.
6 Add +5V from the DC POWER SUPPLY and unload with a
2 Refer to 2-2. to remove the cabinet (R) assembly.
3 Refer to 2-6. to remove the battery panel assembly.
4 Refer to 2-8. to remove the cabinet (L) assembly.
5 Disconnect CN901 of VC-213 board.
6 Add +5V from the DC POWER SUPPLY and unload with a
pressing the cassette lid.
Click on the first or last page to see other DCR-TRV410E / DCR-TRV510E service manuals if exist.