DCR-TRV38, DCR-TRV38E, DCR-TRV39 (serv.man4) - Sony Movie Service Manual (repair manual). Page 11

6-8

Note: When reading or writing the 18, 1B, 1C, 1E or 1F page data, select

page: 0, address: 10, and set data: 01, then select 8, B, C, E or F
page. The 18, 1B, 1C, 1E or 1F page can be chosen by this data
setting.
After reading or writing, reset the data of page: 0, address: 10 to
“00”.

[Connection of the power supply during the initialization of the data.]
1)

Connect the regulated power supply and the digital voltmeter
to the battery terminal as shown in Fig. 6-1-6.

2)

Adjust the output voltage of the regulated power supply so that
the digital voltmeter display is 6.3 

±

 0.1Vdc.

3)

Turn off the power supply.

4)

Turn on the HOLD switch of the adjusting remote commander.

5)

Turn on the power supply.

6)

Perform the initialization of the data.

Note: This is normal though the following message is indicated on

the LCD screen.

“FOR InfoLITHIUM BATTERY ONLY”

[Initialization Procedure]
1.

Initialization of A, D page data

2.

Initialization of B, 1B page data

3.

Initialization of 8, C, 18, 1C page data

4.

Initialization of E, F, 1E, 1F page data

Fig. 6-1-6.

Digital volt meter

Battery terminal

Regulated power supply