Read Sony DCR-TRV250 (serv.man5) Service Manual online
1-2E
DCR-TRV250
&
: Points added portion.
-
: Points changed portion.
1-2. CCD TYPE CHECK
Type of CCD imager can be identified with its serial No.. Check the serial No. printed on the MODEL NUMBER LABEL.
Note:
About VC-305 board and CCD imager, discriminate CCD type on the machine, and replace the same type.
Serial No.
CCD type
VC board
1000000 or before
TYPE SO
VC-305 (TYPE SO)
1000001 or after
TYPE PA
VC-305 (TYPE PA)
––––––––––––––
TYPE SO
VC-304 *1
*1: VC-304 board is TYPE SO only.
Serial No.
MODEL NUMBER LABEL
1-3. JIG MODIFICATION (VC-305 TYPE only)
*
Connect the LANC SIG pin of the I/F unit for LANC control to the land of pin 1 of the CPC jig connector with a jumper wire.
This modification is required in the DCR-TRV250 (VC-305 TYPE) only. Be sure to disconnect the jumper wire when using the I/F unit for
LANC control or CPC jig connector on DCR-TRV250 (VC-304 TYPE).
This modification is required in the DCR-TRV250 (VC-305 TYPE) only. Be sure to disconnect the jumper wire when using the I/F unit for
LANC control or CPC jig connector on DCR-TRV250 (VC-304 TYPE).
1
CPC jig connector
(J-6082-539-A)
LANC jack
LANC
jack
jack
The other side
CX2000
CN1
I/F unit for LANC control
(J-6082-521-A)
(J-6082-521-A)
*
[
Click on the first or last page to see other DCR-TRV250 (serv.man5) service manuals if exist.