Read Sony DCR-TRV24E / DCR-TRV25E / DCR-TRV27E (serv.man2) Service Manual online
2-4
DCR-TRV24E/TRV25E/TRV27E
2-2. EVF SECTION (LB-077 BOARD)
B
A
2
Two tapping screws
(M1.7
×
6)
4
VF cabinet (upper)
assembly
6
VF lens assembly
7
LB-077 board,
Lamp guide
5
Three claws
Prism sheet
Illuminator
3
Two claws
q;
LB-077
board
9
Lamp guide
8
Two claws
1
Raise the EVF in the
direction of the arrow
A
and slide it in the direction
of the arrow
of the arrow
B
.
When separating the
7
LB-077 board and
Lamp guide from the
6
VF lens assembly
by removing the three
5
claws, do not face
the side of the VF lens assembly on which
the LB-077 board is installed, downwards.
Because the Illuminator and others may fall
out of the VF lens assembly, hold the
illuminator and others using tape or paper
as shown to prevent them from falling.
Be careful on this point especially when
removing the LB-077 board and Lamp
guide because the three claws located in
the VF lens assembly are easy to break.
the LB-077 board is installed, downwards.
Because the Illuminator and others may fall
out of the VF lens assembly, hold the
illuminator and others using tape or paper
as shown to prevent them from falling.
Be careful on this point especially when
removing the LB-077 board and Lamp
guide because the three claws located in
the VF lens assembly are easy to break.
Hold the illuminator
and others using
tape or paper as
shown to prevent
them from falling.
and others using
tape or paper as
shown to prevent
them from falling.
Caution
Click on the first or last page to see other DCR-TRV24E / DCR-TRV25E / DCR-TRV27E (serv.man2) service manuals if exist.