DCR-TRV15E, DCR-TRV17E (serv.man2) - Sony Movie Service Manual (repair manual). Page 113

5-5

Fig. 5-1-2.

For details of how remove the cabinet and boards, refer to “2.
DISASSEMBLY”.

When performing only the adjustments, the lens block and boards
need not be disassembled.

1)

Connect the equipment for adjustments according to Fig. 5-1-2.

As removing the cabinet (R) (removing the VC-260 board CN009)
means removing the lithium 3V power supply (BT8301), data such
as date, time, user-set menus will be lost. After completing
adjustments, reset these data. If the cabinet (R) has been removed,
the self-diagnosis data, data on history of use (total drum rotation
time etc. ) will be lost. Before removing, note down the data of
page: 2, address: A2 to AA (data on history of use) and the data of
page: 2, address: B0 to C6 (self-diagnosis data). (Refer to “5-
4.Service Mode” for the data on the history use and the self-
diagnosis data.)

Setting the “Forced Camera Power ON” Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01, and press the PAUSE

button of the adjustment remote commander.

The above procedure will enable the camera power to be turned
on with the control switch block (PS-1700) removed. After
completing adjustments, be sure to exit the “Forced Camera Power
ON Mode”.

Exiting the “Forced Camera Power ON” Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 00, and press the PAUSE

button of the adjustment remote commander.

3) Select page: 0, address: 01, and set data: 00.

1.5 m

Front of the lens

Pattern box