Read Sony DCR-SR15E / DCR-SR20 / DCR-SR20E Service Manual online
DCR-SR15E/SR20/SR20E_L2
1-2E
1-3-3. Self-diagnosis Code Table
Self-diagnosis Code
Symptom/State
Correction
Repaired by:
Block
Function
Detailed
Code
C
0
4
0
0
Non-standard battery is used.
Use the InfoLITHIUM battery.
C
1
3
0
1
Memory card is unformatted.
Memory card is broken.
Format the Memory card.
Insert a new Memory card.
C
1
3
0
2
Disc access error.
Remove the power source. Reconnect it again and operate your
camcorder again.
E
2
0
0
0
Flash memory data are rewritten.
Make flash memory data correct value. (Note)
E
6
1
0
0
Difficult to adjust focus
(Cannot initialize focus).
Inspect the lens block focus reset sensor (pin 8 of CN5401 on the
VC-611 (H) board) when focusing is performed when the focus
button pressed in the focus manual mode, or the focus motor drive
circuit (IC5401 on the VC-611 (H) board) when the focusing is not
performed.
E
6
1
1
0
Zoom operations fault
(Cannot initialize zoom lens).
Inspect the lens block zoom reset sensor (pin 0 of CN5401 on the
VC-611 (H) board) when zooming is performed when the zoom
lever is operated, and the zoom motor drive circuit (IC5401 on the
VC-611 (H) board) when zooming is not performed.
E
6
1
1
1
The abnormalities in initialization of the focus
lens and the abnormalities in initialization of
the zoom lens occurred simultaneously.
Check both E: 61: 00 and E: 61: 10 of the self-diagnosis code.
E
9
4
0
0
Fault of writing to or erasing the flash memory. Inspect the flash memory (IC7801 on the VC-611 (H) board).
E
9
4
0
1
Internal flash memory fault.
Inspect the flash memory (IC7801 on the VC-611 (H) board).
Note: Start the Adjust Manual in the Adjust Station and refer to the “DESTINATION DATA WRITE”.
Click on the first or last page to see other DCR-SR15E / DCR-SR20 / DCR-SR20E service manuals if exist.