Read Sony DCR-SR15E / DCR-SR20 / DCR-SR20E Service Manual online
DCR-SR15E/SR20/SR20E_L2
3-1E
3. ASSEMBLY
Assembly-1: Installation Cautions of Speaker Harness
Speaker
Haeness
Libs
Pass speaker harness in the two libs.
Assembly-2: How to distinguish the side of Optical Filter Block
facing to Lens Device
• IR cut coating surface
the red coating is reflected.
• The other surface
the red coating is
not reflected.
• Side view
the red belt
is seen.
Lens Device side
Lens Device side
Hold it with tweezers or the like.
Optical Filter Block
[IR Cut Coated Side]
[The Other Side]
The one side of the Optical Filter Block has treated with IR cut coating.
Mount the Optical Filter Block facing IR cut coated side to the lens
device. Distinguish the IR cut coated side from other by applying the
fluorescent light to the Optical Filter Block in dark place (cut off outside light).
Assembly-3: Precaution Mounting method of Diode (D1003)
(LED video light)
Diode (NSPL500DS)
Diode (NSPL500DS)
Precaution the polarity.
5.7mm
12.7mm
Bend
Cut
VC-611 (H) Board
Anode
Kathode
Assembly-4: Installation Cautions of Mic Unit.
Route the flexible board
as shown in the figure (image).
Microphone holder
Pass the flexible board of
the mic unit under this lib.
Assembly-5: The Method of attachment of FP-1289 Flexible
Board.
1
Fold dotted line parts of the FP-1289 flexible board
as shown in figure.
Unite corners.
Valley fold
Valley fold
Mountain fold
Mountain fold
Mountain
fold
Marks
Adhesive tape
Adhesive
tape
Adhesive tape
FP-1289 Flexible Board
Valley fold
Marks
2
Put FP-1289 Flexible Board on the Hinge Assy
as shown in figure.
3
Install the flexible clamp in the hinge assy as
shown in figure.
Hinge Assy
Adhesive Part
Flexible clamp
4
Roll the FP-1289 flexible board 2 times in
the hinge assy as shown in figure.
2 times
Click on the first or last page to see other DCR-SR15E / DCR-SR20 / DCR-SR20E service manuals if exist.