Read Sony DCR-PC330 / DCR-PC330E (serv.man3) Service Manual online
Troubleshooting
110
Digital program editing on the tape
does not function.
does not function.
cSet the input selector on the VCR correctly, then check the connection
between your camcorder and the VCR. (p. 86)
cWhen your camcorder is connected to a DV device that is not a Sony
product via an i.LINK cable, select [IR] in step11 of “Step 1: Preparing
your camcorder and VCR for operation” (p. 91).
your camcorder and VCR for operation” (p. 91).
cAdjust the synchronization of the VCR. (p. 94)
cEnter a correct [IR SETUP] code. (p. 93)
cSelect the mode used to cancel recording pause again. (p. 92)
cSet your camcorder and the VCR more than 30 cm (12 in.) apart. (p. 92)
• The program may not be set to a blank section on the tape.
cEnter a correct [IR SETUP] code. (p. 93)
cSelect the mode used to cancel recording pause again. (p. 92)
cSet your camcorder and the VCR more than 30 cm (12 in.) apart. (p. 92)
• The program may not be set to a blank section on the tape.
The VCR is not responding properly
during Digital program editing when
it is connected via an i.LINK cable.
during Digital program editing when
it is connected via an i.LINK cable.
• While connecting via an i.LINK cable, select [IR] in step 11 of “Step 1:
Preparing your camcorder and VCR for operation” (p. 91).
Digital program editing on the
“Memory Stick” does not function
correctly.
“Memory Stick” does not function
correctly.
• The program may not be set to a blank section on the tape.
• You cannot record or a distorted picture may be recorded if the tape has
• You cannot record or a distorted picture may be recorded if the tape has
been used repeatedly for recording.
Symptom
Cause and/or Corrective Actions
Click on the first or last page to see other DCR-PC330 / DCR-PC330E (serv.man3) service manuals if exist.