Read Sony DCR-HC47E / DCR-HC48 / DCR-HC48E (serv.man4) Service Manual online
6-53
DCR-HC47E/HC48/HC48E_ADJ
3-4.
VIDEO SYSTEM ADJUSTMENTS
Before perform the video system adjustments, check that the speci-
fied values of “33MHz/27MHz Origin Oscillation check” of “1-3.
CAMERA SYSTEM ADJUSTMENTS” is satisfied.
Check that the data of page: 0, address: 10 is “00”.
If not, select page: 0, address: 10, and set the data “00”.
fied values of “33MHz/27MHz Origin Oscillation check” of “1-3.
CAMERA SYSTEM ADJUSTMENTS” is satisfied.
Check that the data of page: 0, address: 10 is “00”.
If not, select page: 0, address: 10, and set the data “00”.
Adjusting Procedure:
1. IC4701 LINE OUT Y level adjustment
2. IC4701 LINE OUT chroma level adjustment
3. S VIDEO OUT Y lebel adjustment
4. S VIDEO OUT chroma adjustment
5. IC4701 Automatic adjustment
6. VIDEO OUT level check
1. IC4701 LINE OUT Y level adjustment
2. IC4701 LINE OUT chroma level adjustment
3. S VIDEO OUT Y lebel adjustment
4. S VIDEO OUT chroma adjustment
5. IC4701 Automatic adjustment
6. VIDEO OUT level check
1.
IC4701 LINE OUT Y Level Adjustment (VC-472 board)
Mode
CAMERA-TAPE
Subject
Arbitrary
Measurement Point
Y signal terminal of S VIDEO plug
of A/V OUT jack (75
of A/V OUT jack (75
Ω terminated)
Measuring Instrument
Oscilloscope
Adjustment Page
C
Adjustment Address
80
Specified value
Y level: A = 1000
± 14 mVp-p
Sync level: B = 286
± 6 mVp-p (NTSC)
B = 300
± 6 mVp-p (PAL)
Note 1: Check that the data of page: 0, address: 10 is “00”.
Note 2: NTSC model: DCR-HC48
Note 2: NTSC model: DCR-HC48
PAL model: DCR-HC47E/HC48E
Switch setting
1) DEMO MODE (Menu setting) ........................................ OFF
1) DEMO MODE (Menu setting) ........................................ OFF
Adjusting method:
Order Page Address Data
Procedure
1
0
01
01
2
8
4C
Set the bit value of bit1 is
“0”, and press PAUSE
(Write) button. (Note 3)
“0”, and press PAUSE
(Write) button. (Note 3)
3
3
01
70
Press PAUSE (Write) button.
4
C
80
Change the data and set the Y
signal level (A) to the
specified value.
signal level (A) to the
specified value.
5
C
80
Press PAUSE (Write) button.
6
Check the sync signal level
(B) to the specified value.
(B) to the specified value.
7
3
01
00
Press PAUSE (Write) button.
8
8
4C
Set the bit value of bit1 is
“1”, and press PAUSE
(Write) button. (Note 3)
“1”, and press PAUSE
(Write) button. (Note 3)
9
0
01
00
Note 3: For the bit values, refer to “6-4. SERVICE MODE”, “4-
4. 3. Bit value discrimination”.
H
B
A
Fig. 6-3-3
Click on the first or last page to see other DCR-HC47E / DCR-HC48 / DCR-HC48E (serv.man4) service manuals if exist.