Read Sony DCR-DVD406E / DCR-DVD408 / DCR-DVD408E / DCR-DVD506E / DCR-DVD508 / DCR-DVD508E / DCR-DVD808 / DCR-DVD808E / DCR-DVD908 / DCR-DVD908E (serv.man3) Service Manual online
1-1
DCR-DVD406E/DVD408/DVD408E/DVD506E/DVD508/
DVD508E/DVD808/DVD808E/DVD908/DVD908E_L2
DVD508E/DVD808/DVD808E/DVD908/DVD908E_L2
ENGLISH
JAPANESE
ENGLISH
JAPANESE
1. SERVICE NOTE
1-1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L200/L200B).
1-2. TO TAKE OUT A DISC WHEN NOT EJECT (FORCE EJECT)
1
Remova the screw (M1.7) and front cover (227).
2
Insert the wire etc. in the hole and up the lock arm by it.
1-3. PRECAUTION ON REPLACING THE VC-478 BOARD.
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Refer to Service Manual ADJ, and perform “DESTINATION DATA WRITE”.
Refer to Service Manual ADJ, and perform “DESTINATION DATA WRITE”.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform “USB SERIAL No. INPUT”.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform “USB SERIAL No. INPUT”.
Front cover (227)
Screw (M1.7)
Claw
Hole
Hole
Lock
arm
arm
Click on the first or last page to see other DCR-DVD406E / DCR-DVD408 / DCR-DVD408E / DCR-DVD506E / DCR-DVD508 / DCR-DVD508E / DCR-DVD808 / DCR-DVD808E / DCR-DVD908 / DCR-DVD908E (serv.man3) service manuals if exist.