Read Sony DCR-DVD406E / DCR-DVD408 / DCR-DVD408E / DCR-DVD506E / DCR-DVD508 / DCR-DVD508E / DCR-DVD808 / DCR-DVD808E / DCR-DVD908 / DCR-DVD908E (serv.man2) Service Manual online
DVD508E/DVD808/DVD808E/DVD908/DVD908E_L3
SERVICE MANUAL 9-852-179-13
with this Manual.
mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part num-
ber specified.
marque 0 sont critiques pour la
sécurité.
Ne les remplacer que par une pièce
portant le numéro spécifié.
DVD508E/DVD808/DVD808E/DVD908/DVD908E_L3
BR
EE
J
NE
DVD508E/DVD808/DVD808E/DVD908/DVD908E_L3
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
connections. Check the entire board surface for solder splashes
and bridges.
"pinched" or contact high-wattage resistors.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
• Unleaded solder melts at a temperature about 40
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350
heated tip is applied for too long, so be careful!
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
also be added to ordinary solder.
EXIT WITH THE EYE TOO CLOSELY. IN CASE IT IS
NECESSARY TO CONFIRM LASER BEAM EMISSION,
BE SURE TO OBSERVE FROM A DISTANCE OF MORE
THAN 30 cm FROM THE SURFACE OF THE
OBJECTIVE LENS ON THE OPTICAL PICK-UP BLOCK.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Use of controls or adjustments or performance
procedures other than those specified herein may
result in hazardous radiation exposure.
hazard.
DVD508E/DVD808/DVD808E/DVD908/DVD908E_L3
な部品は必ず指定のものをご使用下さい。
ます。電池を交換する場合には必ず同じ型名の電池
又は同等品と交換してください。