DCR-DVD200, DCR-DVD200E, DCR-DVD300 (serv.man3) - Sony Movie Service Manual (repair manual). Page 122

z

AUTO

ON

To display the remaining capacity of the disc in
the following cases for example:
• For 8 seconds after setting the power on and

the mode dial to 

 (Movie) or 

 (Still)

• For 8 seconds after recognizing the inserted

disc into your camcorder in 

 (Movie) or 

(Still)

• For 8 seconds when set the display to on by

pressing DISPLAY/BATT INFO in 

 (Movie)

or 

 (Still)

• When the remaining capacity of the disc is less

than 5 minutes in 

 (Movie) or 20 in 

 (Still)

• For 8 seconds when starting recording from

the line input

To always display the remaining capacity of
the disc

 Movie
 Still

 Play/Edit

Notes
•If you press DISPLAY/BATT INFO with [DISPLAY] set to [V-OUT/LCD] in the SETUP display,

the picture from a TV or VCR will not appear on the LCD display even when your camcorder is
connected to outputs on the TV or VCR.

•If more than five minutes passes after removing the power source, the [PROGRAM AE], [FLASH

LVL], [WHT BAL], [COMMANDER], and [HiFi SOUND] settings are returned to their factory
settings. Other settings are held in memory even when the battery is removed.

Tip
When recording a close subject, if [REC LAMP] is set to [ON], the red camera recording lamp on
the front of the camcorder may reflect on the subject if it is close. In this case, it is recommended to
set [REC LAMP] to [OFF].