CCD-TR820E, CCD-TR825E, CCD-TR920E, CCD-TR930 - Sony Movie Service Manual (repair manual). Page 4

Read Sony CCD-TR820E / CCD-TR825E / CCD-TR920E / CCD-TR930 Service Manual online

— 4 —
SERVICE NOTE
A
6
Pull the timing belt in the direction of arrow
A
 with a pinsette while pressing the
cassette lid (take care not to damage) to
adjust the bending of a tape.
Timing belt
Pinsette
[DC power supply]
(5V)
Press the cassette lid not to rise
the cassette compartment
+
Adjust the bending of a tape
Loading motor
Timing belt
7
Let go your hold the
cassette lid and rise the
cassette compartment to
take out a cassette.
2. TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1. POWER SUPPLY DURING REPAIRS
In this unit, about 25 seconds after power is supplied (8.4V) to the
battery terminal using the service power cord (J-6082-223-A), the
power is shut off so that the unit cannot operate.
This following two methods are available to prevent this. Take note of
which to use during repairs.
Method 1.
Connect the servicing remote commander RM-95 (J-6082-053-B) to
the LANC jack, and set the remote commander switch to the “ADJ”
side.
Method 2.
Press the following battery switch using adhesive tape, etc.
Battery switch
Battery terminal 
Battery terminal 
Battery SIG terminal
1
Refer to 2-1. to remove the front panel assembly.
2
Refer to 2-2. to remove the cabinet (R) assembly.
3
Refer to 2-8. to remove the battery panel assembly.
4
Refer to 2-10. to remove the cabinet (L) assembly.
5
Add +5V from the DC POWER SUPPLY and unload with
a pressing the cassette lid.
Page of 127
Display

Click on the first or last page to see other CCD-TR820E / CCD-TR825E / CCD-TR920E / CCD-TR930 service manuals if exist.